Unable To Program Sakura-G with AES Example

Hello,

I have followed the Quick Start Guide here yet am unable to get my board to work correctly. I have reprogrammed the FPGAs on the board numerous times with the correct mcs files, and have overwritten the FTDI chip to use the correct driver and hardware on the ports.

My LED status indicators are all matching what they should be except for LED5 (which is turned off). This occurs with or without the OpenADC module attached. I even erased each FPGA and rewrote the mcs files, to no avail.

Any assistance would be appreciated in getting started on the tutorials. With the bottom FPGA programmed following this tutorial, LEDs 1,10,11-18 are ON.

Thanks,
Jason