Hello,
I do not know why the bitstream is not installed to the FPGA using the capture V4.0.0?
I put program FPGA after puting the path of the bitstream and then i do program FPGA.
these are the messanges:
These are the messages when i am trying to download the bitstream:
INFO - Target Disconnected
INFO - Found CW305 Artix FPGA Board, Serial Number = 4420312043304a383330313238313038
INFO - SAM3U Firmware version = 0.20 b0
WARNING - FPGA Done pin failed to go high, check bitstream is for target device.
INFO - Target Connected
WARNING - FPGA Config failed: DONE pin did not go high. Check bitstream is for target device.
Does the bitstream included in the ChipWhisperer install work? It can be found here:
\hardware\victims\cw305_artixtarget\fpga\vivado_examples\aes128_verilog\aes128_verilog.runs\impl_35t\cw305_top.bit
Also, did you try the example in the documentation? It can be found here