Discussions on Python software that powers the ChipWhisperer system
#1467 by florenzo
Fri Jul 14, 2017 3:45 pm
Hello again,

I'm sorry to keep bothering with all my questions but I just can't seem to make things work for me. I'm having a bit of a problem with tutorial B3-1. Whenever a capture is ran, the terminal would suddenly show that I have entered the 'v' character. This causes the program to call it as a Password Fail. Is there something that I'm missing here?

#1470 by gdeon
Mon Jul 17, 2017 7:25 am
Whoops - this is our mistake! We recently added some new features to the target firmware and now the scope is checking which version is being used. Go to Target Settings > Simple Serial > Protocol Version and change it to 1.0 - the 'v' should go away.
#1473 by ExMachina
Thu Jul 20, 2017 8:10 am
so in a little more details

the default target firmware simple serial ./hardware/victims/firmware/simpleserial/simpleserial.c has a 'v' command to get the version of the target firmware
but ./hardware/victims/firmware/glitch-simple/glitchsimple.c does not.

Who is online

Users browsing this forum: No registered users and 2 guests