i made one chip whisperer lite by myself i buy the chips from digi key and assmble them by myself
now i can use chip whisperer capture connect the board and i have already programmed the xmega target.
the firmware and the source code are chipwhisperer-0.12RC1
but i can only catch 3000 waves
1:can you help me about the debug logging
2:is there any hardware wrong may cause this problems
3:the target xmega board LED are always not flash, i do not know why.
Ah… yes you need to program the XMEGA, the CW-Lite has a programmer so no need for a bootloader.
I can upload the hex-file tomorrow, I’m still on the road so don’t have my dev computer with me. But if you have avr-gcc installed you can run “make” in “chipwhisperer\hardware\victims\firmware\simpleserial-aes”.