Hardware Connection

Embedded Security ChipWhisperer Hardware
1

Hi,
For my project, I’m trying to use Chipwhisperer Lite with the XMEGA target for CW308 UFO Board. I do have a whole kit having other target boards and CW506 Advanced Breakout Board etc. Now the issue I’m having is not getting proper hardware connection guidelines for the capture and target boards. Few tutorials showed some connection but that doesn’t match the boards I have. I’m not sure if I’m missing something. I would highly appreciate any documentation or guideline. FYI, I am following the Jupyter Notebook Environment.

Thanks,
Row

2

Hi Row,

You should be able to run all the tutorials using only the 20pin connector and an SMA cable between either the measure or glitch port, depending on the tutorial. The CW506 board is only required if the target doesn’t run at 3.3V.

Alex

1 Like
3

Thanks a lot for the response.

1 Like