No OpenADC detected

Other Products OpenADC
1

Hello everyone,

I have used OpenADC module and Sakura-G board. I use ChipWhisperer 4.02 and the capture V4.02. Everything worked well a month ago, The software captured power traces successfully. But now I can do it again. I do not know why.

This is my settup:
1:
image
2:
image
3:
image
4:

image
image804×489 28 KB

5:
image
image823×517 25.7 KB

I checked and flashed the L9 -Spartan6 with .mcs file in “chipwhisperer-4.02\hardware\capture\sakura-g\sakurag_ise_project\sakurag-chipwhisperer.mcs”

I am wondering if there is a problem with the FTDI driver because now the “Device Serial Number” is “FT58735TA”. However, it was “FT2BDOGUA” before like the picture below
image

Please help me! Thank you very much.

2

This is my hardware setup. I don’t remember if it has the heart-beat led on the Sakura-G?

z2220730417378_06ac6c0106d3794a01315cc3a0e68b20
z2220730417378_06ac6c0106d3794a01315cc3a0e68b201920×2560 1.24 MB

3

Hello, It is fixed!
The FTDI chip on Sakura-Board needs to run on 245-FIFO mode.
Thanks!