Thanks for the tips!
I am stuck on trigger now. The only way I can get a trigger is in the code above. Which is “low” on tio2, my transmit. I think I need to change it to “high” on tio1? How do I know the trigger condition is valid?
Is every call to scope.arm() setting up a new trace?
What is ending the capture in the current loop? Guess I need to go back and read scope again. There’s scope timeout and number of traces… if timeout is 10 and number of traces is 500, is that 500 traces over 10 seconds? I don’t think so.
Meanwhile, I will mess with shunt resistors to find highest level and still function. Remove any caps. Add the SAD function and run attack again.
Starting and Stopping the trace…
Off topic
I picked up the CW506 today. Not sure I will use it for this project but more than likely future one’s.
kinda cool.