Gskim
June 18, 2021, 8:01am
1
hello
i using Chipwhisperer-Lite and the targetboard: CW308(STM32F3)
I am using Windows 10 and i installed ChipWhisperer5_64,
i was study Part 1, Topic 2: Clock Glitching to Dump Memory
but i had problem
after infinite timeout!
and this is result … ummm… i watched in this page
https://chipwhisperer.readthedocs.io/en/latest/tutorials/courses_fault101_soln_fault%201_1%20-openadc-cwlitearm.html
hardly believe my eyes O_O!
Why is this working?
Maybe i was lost one thing, but i can’t find it.
thank you have a nice day
Hi,
Can you verify that the target is actually running? Are you able to communicate with it normally?
Alex
Gskim
June 19, 2021, 1:59am
3
Hi,
this is my target board
example… in Communication with target in Connecting Hardware page?
Building and Uploading firmware
…Skip the middle…
hmm… Do I have to complete this too?
i tried second sentence in upper figure
Sorry to keep bothering.
Regards,
Gskim
In the above, you’ll need to upload the simpleserial-basic firmware (the cw.program()
call). Additionally, can you move the jumper on J3 down one slot so that it’s on HS2/OUT?
Alex
Gskim
June 21, 2021, 12:57am
5
Hi,
sorry to late response.
Thanks, Alex
it works fine. i think “jumper move” is Solution.
Have a nice day
Regards,
Gskim!