Read timed out_Lab3

Embedded Security ChipWhisperer Software
1

Hello there,

I’m trying to run lab3_1. I’m using the CW308_ATSAM4L with CW-Lite, and I’ve been facing this issue for quite a while. I couldn’t figure out how to set it right.

Could anyone tell me how to set the timeout correctly so I can capture traces?

image
image1097×1028 43.2 KB

my scope.specfc:
image
image
image518×1236 18.3 KB

Thanks.

2

Does that “read timed out” error happen right away? Where is the blue progress bar when you first get the error?

1 Like
3

Now it’s working just fine. I found that the tutorial script, when using SimpleSerial version 2, automatically sets the baud rate to 230400, which is not applicable to my SAM4L board, which only works at 38400. It also sets the receiver to low!