Unsing CW Lite for 16Mhz clock generation

Embedded Security ChipWhisperer Hardware
1

I remove the xtal form Traveo II cpu to connect CW L HS2 pin at 16Mhz.
The HS2 looks ok on the osc, but the device do not run.
I think is because the voltage level of the CW Lite is 0 to 4.4V, so I need to down to 0.850V.
I was thinking about to use the 1.7Ghz opam LMH6702 (is what is in stock) or similar.
Is this ok, or there’s another way.

Thanks,

2

CW-lite only supports 3.3V target I/O. It’s very important to keep this in mind when using it with other targets.

Our CW506 does voltage translation, however it doesn’t support such low voltages; you’ll have to look at some other solution to meet your needs.

3

Ok, there’s a way to monitor ext osc to do the clock glitching in the same line monitored?
Maybe with HS2 or ClockGlitching LP

Thanks,

4

I don’t follow.
The glitchy clock has to be generated by CW. CW can’t insert glitches onto some externally generated clock.

5

Ok, understood.
Thanks for your Amaizing support.